C*Pix SDC2000 Betriebsanleitung PDF herunterladen (Seite 282)

4.10 Menu Memo SDC 2002

4-196

Operating Instructions - Rev. 1 / 6.2003

2. Cue1 / 2

settings

Cue moves your material directly to a preselected position.

There are different ways of programming a Cue point. Move the material to

the desired position and hit IN 1. The corresponding counter position will be

entered and displayed above.

Instead of physically playing the material you can also just type it in. There-

fore click on the counter display and a numeric keyline will appear on top of

the page.

Type in the Cue timecode and confirm by pressing the OK button.

Hitting the function KEY 1 or 2 cues your material to the programmed posi-

tion. This is done with shuttle or play depending on the current position of

your film material.

Between the cue points 1 and 2, the selected mode applies. From outside or

by hitting a function key twice, always Shuttle mode is performed.

Freeze

Freeze mode suppresses every frame between the programmed freeze and

defreeze points.

As long as your programmed freeze lasts, the last frame prior the freeze start

will be shown.

Freeze and defreeze can be programmed as described under Loop mode.

Once entered, notice that the bar on the film roll display will be highlighted in

yellow.

Hitting the Freeze button will execute this function if you play your material in

Forward mode starting from somewhere before the freeze in-point.

Note that this function is not available in Play Reverse mode.

Note:

Freeze and Loop functions are not applicable at the same time.

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 365 366

Keine Kommentare

C*Pix SDC2000 Betriebsanleitung Seite 282